trooper1954's latest activity

Hi, I have the above captioned mower that has a priming bulb. After repeated priming the plug does not even look wet....however if I put...

Hi, I have an older trimmer that has a priming bulb. After lots of primes it will not start, until I put a few drops of gas into the...

Thanks Rivets. I thought they were good....so my bad!!! I'll replace both sides, and still wondering if there's a correct way to place...

Hi all, Long story behind the work done on this mower...the most recent thing done to it was to replace the wheel bearing on this...

SO............used mower today, and the grinding noise is still there on the left rear drive wheel only. This is despite a new bearing...

Finally decided to strip the mower down...removed the HOC plate and dropped the axle down.....then pulled the axle through and was able...

i've spent pretty much the whole day trying to get the nut end of the HOC for the new bearing undone.......penetrating oil...

The bearing hoc has no snap ring....so does it just come out?

Thanks Rivets....having a tough time working out where the retainer ring is located....I've tried following the service manual but just...

Apologies......I see now that the nut is actually the end of the retainer bushing for the bearing....at least I think so?

Just a quick question....have the new bearing for this toro 20374 rear left wheel, and wondering if the large nut on the inside of the...