Recent content by tim4

It is a hard plug black plastic I believe.

The plug was not tampered with before I got the machine. I put a little pressure on the tool when I was turning it but the tool does not want to start in to the plug

I tried a left handed tool from echo but it does not screw in to the plug to remove it. I also try to drill the plug gently but it screws up the slot in the adjusting screw. How do other people remove those plugs. thanks.

I thought so but can not tell where it hooks up on the air cleaner. There is a small line on the other side that comes from the air cleaner to the engine can't tell where it goes it goes under the covers maybe a fuel vent.

I noticed to the left of where the carburetor bolts on there is a round pipe that comes from the engine. What is supposed to go on it thanks.

Thank you the engine is a 4 stroke and everything is clean and I replaced the fuel line to the filter and new filter.

We did not see any slot or d slot in the center of the throttle shaft. We even took out a small rubber plug and there was nothing there.

We finally found the model number cmxgvamkc29c

I have a small tiller which has a small wead trimmer engine on it and I replaced fuel filter line and carburetor and when I start it up it idles fine and will accelerate slightly but when I put it on full throttle it bogs down and stalls. When I put on the choke slightly it will run full speed...