Tiger Small Engine's latest activity

I have a Dixon zero turn with a damaged crankshaft. Customer installed new PTO clutch themselves and did not tighten and torque it down...

Heavy scoring on piston in picture. Stop and don’t do any further work on chainsaw. Leave muffler off so you can show customer or know...

No belt length is that critical to a 1/4” inch. There is something else most likely going on that is wrong causing problems with 3 belts...

On the Intek V-twins the push rod will fit through the oil drain back hole from the push rod cavity. Could be the push rod got jammed...

Buy a zero turn versus a riding mower for sure for two acres. Doesn’t matter what brand zero turn you buy at the low end, they are all...

So it seems a shop has to be a bit larger to use Stens, Rotary, and Oregon, as a general rule. I was told before opening up to get...

Awesome. StarTech comes through again, thank you sir

I buy parts from Amazon, EBay, and local Hardware store that is also a Scag, Bad Boy, and Stihl dealer. For me, quality of part...

I normally use PB Blaster for penetrating oil and works great. Kroil is supposed to be better, no real personal experience. One other...

Either you have a bad wire connector, most commonly at the battery, but could be were the ground wire connects to the frame, or the...

Just a hint. I've used the whole valve train from Honda engines in the predator engines. Valves, springs the whole works from Salvage...

What equipment is listed at, and what it actually sells for, are obviously two separate things. I get people nowadays that make lowball...

You must have the same transaxle for replacement as original. IE: T40 Tuff Torq. Otherwise you have to do modifications and it can get...

Carb cleaner and a cordless drill with wire wheel and safety glasses. Then use green Scotchbrite to finish it.

He wants to permanently repair the loose plastic fuel inlet fitting. Not permanently attach a fuel line. Please post the product that...