Tiger Small Engine's latest activity

First check battery to be sure it is at 12.75 volts at rest. Make sure battery is charging. Typical air gaps on PTO clutch is from .016”...

Hit the zerks with heat and a small nail and air compressor blow gun to unclog the fittings. Sometimes it works.

If everything is right, several years.

I grew up in Decatur, Alabama so I know all about the growth in recent years in Huntsville. Huntsville is now the largest city in...

You posted the same question on Lawnsite (another forum). How could anyone possibly know the exact spec on valve guide on that specific...

Trimmers, blowers and well most all outdoor powered gear are meant to run at MAX rpm, all the time. Why? Most are air cooled. The slower...

You don’t have enough load on the engine. Why anyone would take the good line head off and install one where you have to constantly stop...

Sounds like choke is hanging up momentarily, then recovering and running right.

Every engine starts differently, period. Some love no choke most of the time. Some love it to blip the choke if it 100 degrees outside...

Heet allows the fuel and water to mix so that a tiny amount of water can be burned with the gas. Heet will not overcome large amounts of...

On this particular CC it has a separate deck model number which appear to be a 38" deck. Deck secondary belt setup Primary PTO and...

At least run a zip tie around the poor fitting hose. The old pulsa jet carbs and so on with the pulsing breather hoses. The 90 degree...

A big box store will refer you to a local shop and it will cost to fix. A good dealer will make it right for no charge (where you bought...

Not worth the time and money normally to replace bent crankshaft on a Honda Gcv160 or 190. Do your best to straighten it if possible.

It is hard to beat a Scag.