Tiger Small Engine's latest activity

It is call Red Death for a reason. Properly stored fuel is one key to the lack of problems. I just cranked up my Poulan chainsaw...

The Kawasaki FJ is an older engine. Keep an eye on the oil if it is using oil (light gray smoke). There isn’t much more you can do...

Fuel filters don’t always fill up with fuel. Make sure fuel tank vent and or gas cap is venting properly.

Snapper used about a half dozen different discs. Need model number to determine which one you need.

I am not a big fan fan of John Deere. Overpriced, overrated, parts are higher for OEM, and often more difficult to work on. Kawasaki is...

I enjoy greasing equipment. It gives me a certain sense of satisfaction. When there are not grease zerks where they should be on...

I run 87 octane, 10% ethanol in everything from a 37 hp Vanguard to a Stihl BG85 blower, and have no problems. Keep the fuel fresh and...

The pinion and rack gear need to be replaced most likely. The deck has to be removed, and the mower raised up enough for access to the...

You stored it without any gas, but did you run the fuel completely out of the carburetor as you stored it?

Common sense tells me that grease is good for rapidly spinning parts, and no grease is bad. I think people tend to overthink situations...

Solved it! Long story shortened, all it needed was the 3 clutch adjustment bolts tightened. How I got there... Reassembled and...

This sounds like the basic engine has been changed at some point for one with a direct AC charging system and inline diode for battery...

Most people are not going to remove a bearing in a spindle to pack it, before installing it. Nobody is going to remove the bearing once...

Don't just blindly change them, prove where the problem is so you understand better.

The 954-04060 is 1/2 x 96.5 not 1/2 x 95.5. And BTW I have a 200" V-belt measuring tool in my shop but most don't. Not even the local...