Recent content by ThatOneGuy1968

I put a new air vane on it and used the spring I bought from Amazon.. the old vane had a small piece broken off of it somehow.. the new vane was all over the flywheel cover, I had to heat it and teeekvit a little which causedvitvtovgetcstuckvonvthe coil, so I did a little trimming and final got...

Thank you..

Thank you..

Thank you..

Back on this shift problem.. the compression release was definitely bad, I fished all the parts out of it, then replaced the cam shaft, then adjusted the valves.. had to get a new carb and clean out the gas tank.. runs and mows great.. still no shift or reverse.. As to the value of this mower...

Working on a Husqvarna 22V46 riding mower with no juice at the solenoid from the coil wire or the switch when cranking.. Are the test procedures for the brake switch, the Pto switch or the seat switch., Excuse me as I misspoke.. it’s aYTH24V54 Cowboy..

Working on a Husqvarna 22v46, no crank condition.. The starter test bad to ground, I put my power probe on the starter and it pops my probes breaker.. The solenoid tested bad also.. Well I forgot to check for voltage on the two little wires so I put it back together and I have no voltage with...

Ok.. no one has explained it like that to me.. no one has said that the flywheel air pushes the wind vain to the open piosition.. Thank you.. 186T02-2299-B1 It’s also a toro 20331 Cowboy..

How does it open the choke right after you start it.. Cowboy..

Yes it’s moving freely.. I wonder if someone sold me the wrong strength air Cain spring.. but I tried stretching other springs and such for different tensions.. Also the thermostat doesn’t even start to hold it open until it’s pretty much completely warmed up.: Cowboy..

I would have to agree, but I don k now why it’s not opening the choke other than the thermostat is not holding it open until it warms up really good..

This is my first experience with Briggs auto choke with a wind vain and I can’t make it work right no matter what I try.. the thermostat does not work fast enough.. you have to hold the choke open until it gets good and warm.. Hmmm.. I replaced the thermostat and adjusted it properly.. It take...

I have a YTH24V54 that I need a service manual for.: I can’t seem to find any fuses.. The starter is completely dead.. no click or anything.. I disconnected the starter wire and used my power probe to test the starter.. it blows the circuit breaker on my power probe everytime.. I suppose the...

All that seems good.. pretty sure it’s gonna be the cam belt.. Right now I’m trying to remove the flywheel to cleanup and to check the woodruff key.. no luck yet tho.. Built extensions for my puller and now I do not have enuf hands.. Thank you for your reply..

I just got a Honda self propelled and I was told it does not have any compression.. so I pulled the valve cover and I see a belt which I have learned is the cam belt.. I’m new to all this Honda motor thing hoping someone could learn me a thing or two about Honda motors, especially compared to...