Recent content by tcnrepairs

we are 300 miles from any kind of decent hardware store let alone a small engine shop. I will probably take it out and use a bow tie clip or a cotter pin Thx again

This had the old cup style that gets ruined when you take it off. I don't think this rod has a drilled end and I will have to take it out to drill it. I have lot's of the bow style.

any idea where i can find the phony clip that goes onto the rod?

Got it! Rod had fallen out. Thx for your help.

will check

ZT1 42 only turns in 1 direction

ZT 42 Cub cadet only drives off one wheel

I am working on a BS 44 m777 0148b1 that has no spark from either module. I have disconnected the ground wire and still no spark. It just doesn't seem right that both modules should go at the same time?

Ordered a head gasket kit. Thx. T

Thank you. I wiil check it out.+

Working on model 33S777 0004g1. It blows gray/blue smoke after running 2/3 minutes and the small vent on the fuel pump starts to leak oil. Is the diaphragm in the fuel pump leaking. It is the only thing that I can think happening. The oil level is fine (not over filled).

Does a Kohler H265 have a compression relief system?

No but that is next on my list. It almost comes up solid but you can pull it through and then it turns easy until the next time it comes up "really" hard.

I am working on a Kohler SH,6 1/2 HP motor that is hard to pull when it comes up against compression.

Check your battery!