Skippydiesel's latest activity

Hi, Old Toro Wheel horse, 14 hp, Model No 71283, Serial No 240000104? Does anyone know the make & model of the gearbox (GB)...

Kubota?

Oh wait I might be an idiot. Ill get back to this sunday.

Hello L., That is uncommon, but not unheard of. Check for power with a test light, but also verify the grounds are good. Do you have...

If you unplug it and check resistance and get no reading the windings are open in the PTO clutch. You will need a new clutch assembly.

Hello L., If you have a multimeter, Ohm the 2-pins going to the clutch with it disconnected from the chassis harness. If you don't get...

Can you unplug the PTO wires, and the blades still stay engaged? If so, it likely has a seized-up/ failed PTO bearing.

Hello B., Unless the carburetor is badly damaged due to water in the fuel, I suggest a full rebuild or get a replacement carburetor...

This manual may help you out. http://www.tuks.nl/WFCProject/img/Engine_Carburator/81644210-Briggs-Stratton-Service-Manual-L-Head.pdf

That is a Briggs pulsa-prime carb. From the paint looks original to the mower. Not much to repair on those. Make sure the inlet...

Aluminum will still oxidize back to a duller finish.

Oh Ok thank. ... so I'm kinda wasting my time then :-(

Hi CG., I think an oil change at 300 hours in a rider is for lazy people that have more money than they have sense. I see "extended...

Honestly, I would plug the bottom weep hole and put one in the top. With a weep hole at the bottom, it will never keep grease for very...

Good morning. The spindle would rattle, be loose. I could feel the roughness in the deck lift pedal. After disassembling, the bearing...