Skippydiesel's latest activity

Bad Boy 72" deck use 24" blades... also, have you check the tire air pressure to make sure they are all up to spec...?

No I don't than the PN refers to a 24-1/8 blade which is just over 72-3/8 when you multiple by 3. There is no margin for error at this...

OK. I can level the deck front-to-back and give that a try.

You would be surprised. There is no one deck setting to fit all. I have a Gravely Pro Turn 260. Gravely says to set the rear 1/4" to...

It won't be the first time for BB to spec the wrong parts. I got a customer with a 2017 Magnum that they say the short brake cable is...

Are you cutting with the mower RPM set to high, or trying to save gas by cutting at low throttle? Mowing should be done at full throttle...

Okay the center blade is offset forward. And 24-1/8 Blades are only 72-3/8 total width. And tip wear would cause the problem. So the...

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

All way too complicated - I use a piece of malleable aluminium flashing (replaced lead). Can be purchased from the hardware in a small...

Yep, it's too heavy. The idea is to apply a vacuum (negative pressure) effect to the crankcase.

Hi Slomo, I used that trick years ago when I worked in an automotive shop. We occasionally would have a vehicle that the drain plug...

small 22 caliber directly through; but do it in the grass, not a concrete floor ..... 😱

Never spill a drop of oil if the filter is loosened so it can be turned by hand , then a hole is drilled at 12 o'clock in the filter...

Hi ljb, Pull the plug wires and crank the engine a few times while the drain plug is out, then let it sit and drain a little longer...

Looks like the standard 5/9 Briggs voltage regulator used on single cylinder Intek from 10-21 hp engines.