Recent content by Skeefe146

Done! I cut off the spindle, reinstalled and it fired right up. Thanks a million!!

Thanks Forest#2, I’ll do just that. Cheers.

Thanks Bertsmobile1, just wanted to give you an update. The carb solenoid was still working but I didn’t go that route. I just isolated the mag to an independent ground switch and it’s been working well, that is until I failed to turn off the ignition switch fully after the last cut. So the...

Thank you, good advice I’m sure. But what about isolating the mag by running the kill wire through a horn button then to the engine block? Will that work?

I will try that. Thanks.

Hi all, first post here. I’ve been chasing this for a while and it’s got me and all my small engine guru friends stumped. Few years ago, I bought a used Ariens tractor, made by Husqvarna. 42” hydrostatic drive 20hp BS single. Used it for a season, covered it for the winter and fired it up in...