sgkent's latest activity

  • sgkent
    sgkent replied to the thread Intermittent shut off.
    It takes 3 things for a gasoline engine to run, air/fuel, spark, and compression. You will need to monitor the engine to see what is...
  • sgkent
    we are in the Looney state. Here they banned any new hydrocarbon engine that is under 25 HP. As a result, there are a plethora of...
  • sgkent
    sgkent replied to the thread 2004 727k2 won't charge battery.
    voltage has to be DC and it needs to be around 13V - 14V. If the charging circuit isn't putting that out, gotta figure out why.
  • sgkent
    sgkent replied to the thread Mower dies on brake release.
    not familiar with the model. That said, some mowers develop a belt and pulley geometry issue as the brake pad wears. Check the pulley...
  • sgkent
    take it to the dealer before you lose or cancel out your warranty. In the meantime loosen the gas cap just a little and see if that...
  • sgkent
    sgkent replied to the thread engine will not run.
    Check the valve guides
  • sgkent
    sgkent replied to the thread Yth21k46 96045002100 pivot bolt.
    is the bushing oilite or plastic? If it is oilite the proper way to install it is hold you thumb or hand over one side, fill it with oil...
    • oilite.jpg
  • sgkent
    sgkent replied to the thread engine will not run.
    45 is awfully low. If it doesn't come up, even if you get it going what will the power be? Like that is about a 4:1 compression ratio...
  • sgkent
    yeah right. Had a CJ7 that loved to build up carbon. One night while the manifold was off I took some chunks of carbon and put them in...
  • sgkent
    sgkent replied to the thread ZT-200 problems.
    Are you saying that even the starter does not turn over? Might want to get the volt meter out, check the battery voltage while turning...
  • sgkent
    you need to pit down enough that someone can answer your question. need the actual engine number and serial In general there are many...
  • sgkent
    sgkent replied to the thread Oil measurement question.
    ??????? Maybe with a transparent tube.
  • sgkent
    sgkent reacted to slomo's post in the thread Oil measurement question with Like Like.
    As in PRIOR to EVERY mow.
  • sgkent
    sgkent replied to the thread Tecumseh Broke Rod.
    unless you can find a core engine locally that runs or can be rebuilt, that engine is way more costly to rebuild than buying a new one...
  • sgkent
    sgkent replied to the thread Oil measurement question.
    everyone missed the point so I will make it again. Pushing "the dipstick back in" is capable of yielding two different results. If the...
    • dip.jpg
Back
Top