sgkent's latest activity

Check the valve guides

is the bushing oilite or plastic? If it is oilite the proper way to install it is hold you thumb or hand over one side, fill it with oil...

45 is awfully low. If it doesn't come up, even if you get it going what will the power be? Like that is about a 4:1 compression ratio...

yeah right. Had a CJ7 that loved to build up carbon. One night while the manifold was off I took some chunks of carbon and put them in...

Are you saying that even the starter does not turn over? Might want to get the volt meter out, check the battery voltage while turning...

you need to pit down enough that someone can answer your question. need the actual engine number and serial In general there are many...

??????? Maybe with a transparent tube.

As in PRIOR to EVERY mow.

unless you can find a core engine locally that runs or can be rebuilt, that engine is way more costly to rebuild than buying a new one...

everyone missed the point so I will make it again. Pushing "the dipstick back in" is capable of yielding two different results. If the...

maybe bad fuel that varnished the stems and they grabbed. I did not believe in that being a possibility but have seen some videos of...

you are going to get many conflicting answers on this. Many dipsticks that screw in have a notch that allows a bump on the dipstick to...

Sounds like the last few years you have experienced some health problems. Try to take things a little slower and take care of yourself...

Did you try Google? I put the carb type in, found...

yes. that is why I posted it, in case someone is searching it. When I cleaned it and put it back together after rebuilding the engine, I...