sgkent's latest activity

  • sgkent
    sgkent replied to the thread Flywheel adapter 611032.
    if it is two cycle don't forget the oil if it uses a 2 cycle mix.
  • sgkent
    sgkent replied to the thread 8HP Briggs Governor Shaft Leak.
    check the oil level, and for gas in the oil
  • sgkent
    sgkent replied to the thread When a battery is really DEAD.
    wiring replacement after a fire or overcurrent melt is about the worst job out there. I excel at finding and fixing electrical and...
  • sgkent
    I usually use a loop of wire around any spring that I can't pull with vise grips or some kind of spring puller like auto drum brakes take.
  • sgkent
    sgkent replied to the thread Flywheel adapter 611032.
    Unless the spark plug was from a known good source, I'd try another. Then I would blow the cylinder out with compressed air to dry it...
    • adapter.jpg
  • sgkent
    sgkent replied to the thread Carb Cleaning Question.
    FYI - regular simple green will dissolve some carbs. The HD Metal Safe version doesn't do that. Home Depot is the easiest place to get...
  • sgkent
    there was a youtube on it recently. The new caps lack the hole. It has to be in a certain spot to stop gas from sloshing out. Starts...
  • sgkent
    sgkent replied to the thread Carb Cleaning Question.
    set it into the fluid in a way that the air can get out. Use "Simple Green Pro HD SAFE FOR METALS" with hot water and you will get metal...
    • hd.jpg
  • sgkent
    most lead acid batteries are degraded enough by 4 years to replace them. Some people consider 50 - 60% life left good. Others replace...
  • sgkent
    sgkent replied to the thread Chop saw carb prob..
    did you check the three lines to be sure they are on the correct nipple?
  • sgkent
    sgkent replied to the thread Chop saw carb prob..
    I don't own one but have had the 3 hose style on other engines that used a ZAMA type carb. Here is what Google AI says about hooking the...
  • sgkent
    sgkent replied to the thread Chop saw carb prob..
    Does the carb have 3 lines on it? Main fuel inlet, primer return, and carb to primer suction? If so make sure they are all going to the...
  • sgkent
    sgkent replied to the thread Chop saw carb prob..
    did you go with a generic carb or the manufacturer's part? Does the behavior change when it is choked?
  • sgkent
    sgkent replied to the thread Discharge problem..
    probably falls on deaf ears since he has not been back, but discharging grass out a chute takes air coming in to carry it out. If the...
  • sgkent
    sgkent replied to the thread Troy-Bilt Bronco will not start.
    batteries often show reasonable voltage but if a cell is weak, it will drop way down under load. Of course there can be a dirty...
Back
Top