SeniorCitizen's latest activity

Turn it over , clean , dry . then apply a heavy coating of paraffin . A 1,500 watt heat gun or propane torch will melt a thick coating on .

I agree , balance is important and I use my pocket knife and know where center is . You say , how in hell does that ole man know where...

Not round

From your description, it needs the valves adjusted so the compression release will work. If it still fights the compression after...

With a propane torch , slowly move the flame from the outer edge area and work the way into the shaft .. Not hot but about 30° above...

To make a better blade , stoodite weld wire has been available for nearly a century . Research the hardening process. I realize the...

install shelf liner in the bottom and use it for storage . It's mouse proof .

Maybe use Edit ?

To compare spacer length it's easy to feel the any difference or use a vernier caliper , by setting the housing on about something like...

The reason i don't press one in is to accommodate the expansion forces when those parts increase in length as they gain temperature ...

Is there a reason the date of a post isn't bold print ?

Many have both bearings pressed in . The last JD i replaced the bearings on had the top bearing a push fit . Those that don't have i...

The next time you have the chance measure the length of the spacer and compare that measurement to the distance apart the 2 outer...

Just now, just for Schlitz and giggles, I got the jack out of the car, jacked up the front of the Snapper, and lowered it onto the...

Those with a spacer between the 2 bearings , at minimum 1 of those 2 bearings needs to be a push fit . ie - the outer race needs to be...