Rivets's latest activity

Definitely would have the dealer check it out ASAP, as if could be a bad bearing.

Without knowing the model and serial numbers for both units we would have to offer guesses only. Guessing normally ends up costing...

Must’ve had a brain fart when I posted .020”. hlw49 is correct at .008”-.010”. Sorry about that.

Air gap should be set at .020”

A single blade mower which leaves a high part down the middle? This is something I’ve never seen. Going to keep my eye on this thread...

Did you level the deck by using the blade tips or deck shell? Did use an OEM belt? John Deere tractors are very fussy. Is the center...

First thing to check is a level deck. Check your operators manual on how to adjust the deck.

Sorry I didn’t go back and read all posts, Just reacted to the posts on this page. I did say it was a stupid question.

I wish I had a nickel for every time I’ve seen a DIY guy make this mistake. In 40 years working on Toros I could but myself a good...

Time to ask the stupid question. Have you tried putting in an inline spark tester to determine whether it is a fuel problem or ignition...

Check the oil level, see if it smells like gas. Remember Honda mower engines, the oil level is checked WITHOUT screwing the dipstick...

we have a Toro 20055 that is about 2006 vintage. I went thru the engine a month or so ago, and basically remanufactured it after 20...

Had one like that a few years ago. What I found was that the blade was slowing down or just stopping because the belt was not riding...

Section 7A of this manual describes how to install the rewind spring...

I doubt it.