Rivets's latest activity

Not everyone,. If you really knew what you’re doing you would know that the experienced techs on this forum need all engine numbers so...

Depending on the engine model it not have one, but simply use a diode rectified system. Use this manual to identify which system you...

Post your units model and serial numbers. With them we can tell you which switch you need. Many switches look the same, but are very...

Check to see if it is Lazer etched into the side of the block.

Besides a plugged fixed jet, I’ve found that over time the float needle tip expands, resulting in a drop in fuel level in the float...

Here is the wiring diagram you will need...

Looks like a Simplicity tractor. Simplicity started building NFL and NCAA branded tractors about 1996. If I remember right, I think...

I wouldn’t go after the ignition switch before doing some electrical troubleshooting. Making any component assumptions could lead to...

A multimeter will be your best friend when troubleshooting this problem. If your daughter can get you the model number from under the...

I think that’s what I posted??

Tape measure would have told us deck size!!!

I’m guessing Husqvarna, sure looks like this one. https://www.ebay.com/itm/127360612885 It would have been a lot easier if the OP would...

This manual may help you out. http://www.tuks.nl/WFCProject/img/Engine_Carburator/81644210-Briggs-Stratton-Service-Manual-L-Head.pdf

Are you talking about the cogged timing pulley? This pulley should be tight to the shaft and there is no bearing, which I think you are...

No, the convex goes toward the pulley, so pres is applied to the pulley not the nut.