Rivets's latest activity

  • R
    Rivets replied to the thread unusual pulley.
    I’m assuming you are referring to the drive pulley. We are going to need the model and serial numbers, normally located under the seat...
  • R
    Rivets replied to the thread Changed my mind.
    I’m not bad mouthing TORO, just the Super Recycler version.
  • R
    Rivets replied to the thread Starting Issue.
    Sounds like you have an intermittent short in a component or wiring harness. This is going to take some patient electrical...
  • R
    Rivets replied to the thread Z530M running issues.
    Stop everything. Do not try to fix even the most simplest thing. Voiding the warranty at this point could be the dumbest decision you...
  • R
    That number you posted is for Australia, might want to try the number for Wauwatosa
  • R
    Rivets replied to the thread Changed my mind.
    Guess you’ve never read my previous replies to what is the best push mower to purchase. I used to say that even the cost of the Toro...
  • R
    Rivets replied to the thread Changed my mind.
    While we were talking the one thing that really surprised me was when the owner said that Toro support was very poor on these mowers. I...
  • R
    Rivets posted the thread Changed my mind in Pro Talk.
    To all who have followed this forum for a long time, you will know that I have been a strong supporter of the Toro 21” Super Recycler...
  • R
    Try this site. https://www.briggsandstratton.com/au/en_au/support.html The date code should be listed in the same area as the model and...
  • R
    Rivets replied to the thread Husqvarna 128LD.
    What gave me the impression you thought it was a piece of junk??? 1. My cheap neighbor 2. Bought at a pawn shop for $20 3. Condition...
  • R
    Rivets replied to the thread Husqvarna 128LD.
    Boy you’re making a lot of fuss on a piece of equipment that’s leaking fuel!!! Maybe if you would spend a little time telling us where...
  • R
    Rivets replied to the thread Scag Serial Number.
    Best advice I can give you is to take the engine numbers to a Scag dealer and see if they can back check which models use that engine...
  • R
    I’ve been servicing mowers for 50 years and Craftsman is a mower I would never recommend. A steel deck mower will never last 20 years...
  • R
    Rivets replied to the thread Belt Life.
    All depends what the type of use, keeping the deck top and bottom clean, checking all pulleys, etc. Most manufacturers recommend...
  • R
    Rivets replied to the thread Valve guide moved.
    Verify that the guide has moved before replacing the head. As I stated the guide does protrude above the head base. A good repair shop...
Top