Rivets's latest activity

Did you install the pump diaphragm and gasket in the proper order? Plus tighten the screws in the proper sequence? Section 3, page 9...

Banging on a starter is not a good idea, you can do more harm than good. Might have to replace the starter. If you have a tech in your...

The individual tabs on the back of the switch are labeled..

First thing that comes to mind, are you sure that your new key switch is identical to the old one? They may look the same, but you must...

I guess I read this thread wrong, as I was assuming the OP was looking for trimmer brands, not line brands. Sorry about that. I use...

Try this procedure which I use on my Echo. Put the choke on fully closed. Put the rope 2 or 3 times, until you hear it pop. Move...

Before bad mouthing anything, take it back and have the mechanic take a look at it. At a good repair shop and in a reasonable time...

Before doing anything more remove the key and bolt. Then take some medium/fine abrasive paper and polish the crankshaft until it is...

This is the trimmer I recommend to anyone that asks. I bought this 8 years ago and have had absolutely no problems, and I’ve abused it...

This service manual should answer all your questions...

This service manual will explain how to adjust the governor...

Check your RPMs, if it is running below 3400, adjust. Running below the clippings will not be cut or thrown out properly.

This is the procedure I use. Report back with your findings and we’ll work from there. Electrical problems can be very easy or very...

Thank you for educating me, I’ve always called that the front axle, learned something new today. Normally they should move freely, but...

Pivot bar is the terminalogy that SBD uses for the front axle. Like Stihl uses rope rotor for the starter rope pulley