RevB's latest activity

Called pre-ignition. A hot bit of carbon, a sliver of metal that is hot enough to ignite fuel vapor...

Hi BrentW, My guess is that you are pumping grease into a spindle housing with sealed bearings. It is a cruel engineering joke for many...

If the pump gaskets are stiff and inoperable the exact opposite of what you describe will be the condition.

If it's flooded, simply remove the spark plug and pull it over a few times...then wait. Fuel will evaporate. Install plug, reattempt...

Hi BGS mex, For true load testing, rig an old round incandescent head lamp and use it for load testing the wires. Ohm testing can...

Like trimmer line can't as well.

Trace the white back and run a separate new wire to the switch S terminal that supplies the 12v solenoid. If that works you're looking...

May want to try a test light on that white wire to see if it will light a light. Just because a meter shows 12 volts doesn't mean it...

A replacement head that uses cable or wire rope. That'll keep you busy trimming and not changing line all the time.

Those cheap modules can be used to convert an old points and condenser saw to electronic trigger so don't see why they wouldn't work the...

It's been my experience, the best way for me to get the line into the tank, is to cut a long taper in the line end and start it into the...

Have you checked to make sure there isn't gas in the float making it sink and not stop fuel flow at the float needle. Floats on...

Check for a broken ground (black wire) that doubles from the headlights and back to the start solenoid. I have seen that strange wiring...

Ground?

I think it's more "disturbing the Force"......electric mowers have that effect.