RevB's latest activity

this young man deserves all the support we can give him. Not many 17 YO's are out getting grease under their fingernails. Many young...

If the lathe was second hand it would need to be spotlessly clean and sanitised/disinfected Being an island we do not have a lot of...

That is also true....been watching Cutting Edge Engineering's YouTube channel out of AUS....some of the prices are outrageous for parts...

You don't have a clue about import fees, do ya. 🙄

I got my money back and will take the Husqvarna parts to my local lawn mower (friend) shop and do a swap for something Kohler Also...

The term "DIESELING" is usually used to describe an engine that continues to run after ignition turned of due to SPONTANEOUS...

I'm at a loss about your "fuel shut off" . Is this the carburetor solenoid or a manual valve? The solenoid is only $16 or less from...

My first thought is the ignition modules are not being shutdown when the key is switched off. So they are continuing to produce spark...

Don't pay attention to some of the "advice" you're getting. Some of these guys think they're God's gift to mechanics. Others are the...

Christ almighty.....🤫🙄

Timing marks are definitely good I remember triple checking before I put it back together I just plugged the hole when i disconnected...

No. Unless you're trying to keep the rings from seating.

Just a heads up....Generac had a huge amount of air filters that were made in the Phillipines about 5 years back. They were spec'ed to...

For what it is....18mm to 14mm plug adapter. Way cheaper.

Hello L., That hole is supposed to get filtered air if it has the correct air filter. Your parts picture is the wrong one according to...