Recent content by rdavis0627

Thanks so much as always it’s appreciated, have a good day.

Hi, I've done a bit of googling too much almost and also searched this forum and threads either it's not on here which I doubt or I can't get the right key words to pull it up. Can some one tell me how to make this adjustment or tell me what the type or carburetor name is so I can attempt to...

ok, so I did some internet hopping yesterday, What is a home remedy way of checking for flatness? other than just setting on a flat surface and checking for wobble, I couldn't find anything except sanding the head down?

Thanks so much never thought of that.

Hi, I saw that on you tube I don't have that tool. Did not think about pricing one as yet. Thank you

Hi, Good morning, I did not check it for flatness going to look up some you tubes to see how that should be done, I believe I torqued them to 250in/lbs which I believe is about 18ft/lbs. Not sure about the 3 step torque though so I'll attempt to find that information as well, I'm not sure I had...

Hi I'm re-replying to this thread as the mower lasted a couple of cuts then I noticed some smoking toward the end it went through a lot of oil. I pulled the plug and yup oily plug again. Is there something I could of missed it sounded and ran really good for those couple of times after I...