Recent content by RayMcD

6 acres on bumpy zero turn will do anyone in, get a tractor, JMHO, Cheers

couple drops of Kroil will work wonders...Cheers,

You can pay a whole lot more for this device, but I am not sure if it a whole lot better. Couldn't be happier with how my mower runs after using this device. Recent Convert, Cheers, Ray https://www.amazon.com/dp/B0F2F46C7H?psc=1&ref=ppx_pop_dt_b_asin_title

Gentlemen, I've got the motor running fine Clockwise. According to the info I obtained, the only mechanical issue that must be completed now is to alter the head adapter so that it will not unscrew, I intend to drill and add a small roll pin. Turning around the line cuter will make it work...

I find myself interested in having a straight shaft battery trimmer that would turn clockwise, I'm right-handed and it simply feels like I'm walking backwards going to the left all the time to keep the waste out of the flower beds. I understand the Husq 520ilx is selectable and that some have...

Kroil Penetrating oil, work wonders ...

separate the battery and starter connections, clean, coat with dielectric grease and reconnect. Neighbors machine did exactly the same thing, it was simply corrosion on the cables. Components are made if dissimilar metals and are prone to corrode between the layers. Cheers, Ray

Hi Rivet, well said about the analog meter, my Chief used to go to Radio shack and purchase all the returned faulty meters, bring them on-board, use them for training, repair and sell to the crew for little to nothing. If your 12 volt battery drops below 12 volts it either needs charging or is...

WoW, who put up **** for brains !!!!!!

Here's my home-made grass shut for my little JD LT133 trim mower. It works super, Ray

Sir, tell us where you are and maybe someone will be close enough to come assist..Ray

Mark, this rug has been beat many times, I think I can say we all fight this issue and many of us have tried it all. I use (EZ-Slide Graphite Aerosol) on my Toro push mower with good results, stays on push mower pretty good but a big machine will push it off rather quickly, I only trim and cut...

Try this...

Knots, if the hole size is the issue simply make a bushing and use the 1" hole. Ray

I happy to say the little machine is now purring. First let me correct myself, there is only 5 relays including the starter relay. I replaced all but the starter relay which clearly was working. I went through the entire machine and cleaned all connections and used die-electric grease...