Recent content by parkboy
-
P
Restoring a 24 inch walk behind model 4302, D-402 engine
What you have there is the business end of Lawn Boy Loafer (riding mower). Do you have the rider powered unit 9213 that fastens behind it? I am very sure that it has the mag deck and <MAGNESIUM> should be cast in smaller type in the casting on top of the deck just above the larger type PLACE... -
P
LB 3060 Made in Peterborough, Canada
Do any of you guys have a model 3060 18", aluminum deck, Lawn Boy with F engine? -
P
Need Good Mag Deck
I need a good magnesium deck for a 7252? Anybody have one to sell or trade? -
P
1964 Bricktop restore
I recently got a 1964 Model 5273 bricktop and it is of special significance for me as it was made the year I graduated high school. This old girl is in good running condition, but it is missing the flywheel screen part no. 604271 and ring 604272. I'd really like to get these pieces so I can... -
P
Ready for another 40 years!
Just finished up getting the 1977 model 5024 ready for another season. I repaired all the dings and dents in the shroud, repainted and applied a new set of Graveyard Mowerz decals. Put in new points and condenser and plug. Cleaned out muffler, put in new exhaust gasket seal and lower seal... -
P
Need chrome flywheel screen
Does anyone have a chrome flywheel screen LB part# 604272????????? -
P
Winter project....
Does anybody have a good handle for a 7256? Or, does somebody need a 7256 for their handle? Parkboy -
P
10343?????????????
I picked up a 10343 a couple of weeks ago, which looked like it had not been used much. I cleaned out the carburetor and it ran really good. So, I put a mulch plate in and mulched the leaves in 2 yards and made a $100.00! I looked up the serial and model numbers and found that this outfit was... -
P
Seal for fuel shutoff?
Where can I get a replacement seal/O ring for the fuel shutoff petcock on my Lawn-Boy 5024? Parkboy -
P
New handle covering material?
Where can I get "shrink to fit" plastic to make new handle grips for lawn Boys? Parkboy -
P
Hi/Lo speed selector on 5243????
I just rebuilt a 5243 "suitcase" that has turned out really nice. However, I can't seem to figure out how the shaft from the Hi/Lo speed selector lever on the back of the shroud connects up to the governor linkage and I can't find any diagrams that show it. Anyone know? Parkboy