Recent content by packardv8

  1. P

    Toro Timecutter SS 4250 blade bearing noise

    The bad news is all the bearings go bad. The good news is that spindles and idler pulleys are inexpensive and easy to replace. When I did mine, the bolts which hold the spindles all came free. Thus, I just replaced the bearings. Don't go with cheapest Chicom; spend a bit more for Timken...
  2. P

    Hard to start Toro Z-Turn

    Choke hard on, throttle full on. If still doesn't start, disconnect both ends of both battery cables and clean them. If it still doesn't start, spray with starter fluid. If it then starts immediately, most likely needs a fuel pump. jack vines
Top