Recent content by OldChipper

a few years ago I purchased this Huskee 2010 LT4200 (MTD) 7 speed shift-on-the-go. Was in great shape, other than blown engine, seller said no one told him to change the oil??????? OK! Installed new engine. Has worked like a new one until this year. This year it keeps throwing the deck belt...

I'm installing a Briggs & Stratton 33R877-0003-G1 19 HP Intek 9 Amp Tri-circuit extended life series engine in 1997 riding mower. Ready to go except for wiring. The 6 pin connector has 4 wires, a Gray(afterfire solenoid); Black(kill); Red (?); Orange(?) I need to verify that Red is charging...

My 97 wheeled string trimmer finally worn out the 6HP B&S engine. Everything else is still in good shape. I have a nearly new 6.5HP engine, that would fit. Only problem is ,the output shaft is over an inch to short! I could easily make a shaft extension, (I'm a old retired experimental...

I have 42 inch rider with a 18.5HP Briggs and Stratton 303777 twin engine. Been running great with regular maintenance. But lately it will run for 45-60 minutes and dies, as if it is not getting fuel. 1st time I thought no problem, dirty fuel filter, replaced it even through the old one looked...