Recent content by newyota

Found a old thread dating back to 2013 here and ending in 2016.Oil seal numbers listed for National Seals.472311 for tines..254270 for back pulley shaft seal.Wish I dig deeper here but,o well..guy says it is the same tiller as an IH 526.

outer rubber on seal ruined so no numbers and trying to get exact OD was difficult due to shaft still in and getting calipers in there..Guy at vendor concurred with me on the 1.42 or 1.4387 size.thanks

Thanks

Just wondering how you got the 1.38 size..When I measured for the O.D I got 1.42 roughly before buying the 1.437.

That is the tine axle seal that I had just replaced and I bought a 1x1.437 single cause that’s all I could get locally. Need #45 from what I see For rear seal.

I googled the name and model # and that’s how I found a owners manual with a parts diagram.

Been trying to revive this old tiller.Got the engine going then the gear box right tine axle seal leaked.Alittle struggle to figure out o.d. size of seal.Now go look for anymore leaks and two days later the rear drive seal for pulleys is leaking.Found old parts manual on line but the numbers are...