Recent content by naimc

Actually that HB32 is not the same model at all. the Costco unit is PW 3200 its clearly made by B&S its has B&S sticker model 020798 rev , Husqvaran AB and it used under license to Briggs & Stratton. LLC. I wanted to adjust the valve lash. I use the service manual for the 13u200 as it...

I am trying to find the B&S service manual for the Husqvarna branded pressure washer sold exclusively at Costco. PW 3200. The part number on the engine says 13U2-80098013. I did find a repair manual for 13U200 engines here ...

Thank you for pressions on the term nothing worse than ignorance. Interesting "powder pressing" the term and process does inspire confidence.

Interesting, the blade adapters are fragile ! In my case I was the cause of my misfortunes, 1st I put the blade on with an impact gun set on the highest torque setting, I should never had used the beast of tool. I broke two adapter on the same day. ( other mower) Yes is used a proper torque...

I "reassembled" the motor , ordered the original blade adapter with blade. Mower started on 1st pull no signs of back kick on level pavement. Right after it started I heard a loud clang. stopped the mower flipped it over and found the blade adapter broke ! The motor is just on a temporary...

thank you very much !, Now I was still confused as did not know the bottom cover was called the Sump. So I googled Fastener Torque and I am now in gear head heaven with the ( MTD Profession shop manual ) ...

The mower was made by MDT the marking indicate its a 1P70FUA

Noob, me takes apart his mower engine because I thought damage was causing a backfire, Not the case I was running the engine without the blade. I did that here : https://www.lawnmowerforum.com/threads/mtd-yardwork-mower-kick-back-is-flywheel-key-damaged.60151/page-2 Now I started to...

Update, the engine was sitting on in my garage for a few months, I finally opened it up and surprise ! I can't find anything wrong. Except I did now what to look for so I took out the cam gear without 1st looking of pins were still aligned. Here are some pics of the inside : I moved the gear...

I called a local shop. I was expecting the part to cost 30-40 dollars as in Canada everything is more expensive but surprise was quote $13 so I ordered one but it back order. So will try my welding skills while I wait for the new part.

I got two Husqvarna HU700H mowers for very cheap. both honda GCV engine are in good shape but the bodies have some issues. I took apart this braket yesterday and would like to know if I should attemp a repair weld. I have just about zero welding skills but I do have a flux core small welder...

I reset the flywheel with the existing key as there is no obvious damage and I also adjusted the valves as spec on the mower .10mm intake, .15mm exhaust ( which works to to .004 inches intake, and .006 exhaust) I tried to start the engine again using my drill with 1/4 to 1/2 dewalt adapter...

I will adjust the valves and cross my fingers that that tiny indent see on the left is not enough to throw the timming off. I'll bring the flywheel and old key to local small engine repair place as I can't find much about this made in china MTD engine online. No parts, no manual etc. Here is...

Hi my brother broke the balde off his Yardword mower MTD OEM I think. I opened up the top head of the mower and inspected the piston and valves for damage. I found none so I just cleaned everything up removing all the carbon build up. I did not adjust the vavles. After cleaning the...