Recent content by mudsup

The exhaust outlet is attached directly to the muffler of the unit with exhaust flex pipe to galvanize pipe. 2 sides of the walls have a 4x16 inch wide opening at the top that I fill with foam pads that I can remove depending on heat and wind conditions, Basically the only time I go in is to...

Purchased Saturday morning, Installed that morning Did a trial run that afternoon, Tried to find a solution Returned to store on Wed. Picked up the 10000 watt Champion that morning, Installed and ran all afternoon Dewalt said to to send it to a service center For something that was purchased...

Thank You for the replies Well disconnected everything and fired it up outside, Stopped again after 3 minutes. After calling customer service, Turned out the sensor was bad so brought it back and picked up another Champion

Thank You … Thats the reason for the shed that is 35 feet from the house, Then I run a line from the shed to the house when needed. It’s connected to outboard motor fuel tank’s (12 Gallons) on shelves with quick disconnects The Champion ran for 10 years with that setup

My Champion 7500 watt generator was having problems, So picked up a Dewalt 8000/10000 ( Have read good reviews on this Gen) Gen for a upcoming storm Have a 8X8 shed that the Gen sits in hooked to a fuse panel. Have a exhaust pipe to vent gases and a exhaust fan. Hooked up the Dewalt ran...