MParr's latest activity

Hello, Tiger, Small Engine, I cannot recall ever replacing a rider engine flywheel key unless a DIY type forgot to tighten the center...

40 grit flapper wheel on an angle grinder.

I'll be getting a flap grinder for my Makita .

Which never happens. Used motor oil slathered under the deck works like a charm. Great way to recycle.

Angle grinder. Hang it on a nail.

After 18 replies, 3 different starter replacement attempts and jumping with a vehicle battery, the obvious that has been explained is...

I understand your fustration, but go out into the country sometime then they are mowing side ditches with the rotary cutters and half...

That is about the correct location for rod breakage when the rod seizes to the crank from lack of lubrication failure. And the bolts...

Hello Mjhover, Sounds like a plan. Make sure you have a way to transport it in the future if needed. Pickup and delivery are never...

I think I’m going to go with the Hustler raptor xd 60in. And going to get it from a local hustler dealer

We're all knocking on wood daily here but it does seem like things are patched up. I've been watching the logs and they haven't been...

Red and tacky is all I use and buy it by the case. If it were so bad (slomo) how do they sell so much of it? Ha ha 2x

I have the Valvoline Extreme Red in a new dedicated gun just for the spindles. This is the third set of bearings in less than 500 hours...

https://www.valvolineglobal.com/en/cerulean-grease/ https://www.valvolineglobal.com/en/extreme-red-grease/

Ebay turns up with good used rider engines pretty often. Most people trash their mower decks long before the engine breaks down...