Recent content by mikemurphy

Thank you ALL for your input and suggestions. Finally figured it out, albeit by accident. The mower was running, I got frustrated, hit the plastic that houses the control panel and the blades start spinning! Re-checked all the wiring and connections resulting in finding 1 wire that wasn't fully...

Never used a pressure washer on it however, it has been left out on occasion. I will try another ignition switch. and still had to check power at clutch.

Put volt meter to the PTO switch, checks out. Fuse is good. belt is good. I will check clutch voltage and ignition switch tomorrow. should I be able to advance the blade belt by hand? mike

?

I've a POULANPRO P61ZXT zero turn mower, purchased 4/2017. regularly maintained. Mowed 1/2 of the farm, stopped for lunch, resumed mowing 30 minutes later. Mower started fine a it always has, pulled up on the BLADE ENGAGEMENT KNOB, nothing. No movement at all in the blades. Tried this multiple...