Recent content by mikekrawczyk

Thank you

I will give it a whack,and let you know what happens

Cooling fans ok, what would cause 2 valves to stick at the same time?

I have another problem. Just for the heck of it, I straightened the push rod with a hammer, put it back in, and turned it by hand to see if everything was good. before my eyes, The push rod bent again. it looked like the valve wouldn't go down, this is a twin engine?????.

again thank you, guys! Here is a pic of my homemade leak tester, Maybe someone can make one for themselves.

I did a leak test on it, air was leaking through the exhaust. Then I took off the valve cover and found this!

Thank you.

Sounds good. I read somewhere you can use air to check if the valve is open. Is that true? Thank you for the advice.

The pistons are moving, not sure about the valves. How would I check that?

I was told you cannot check compression on that type of engine.

it has spark.it is a K I checked that it's ok. Thank you for the advice, I appreciate it a lot. I still cannot figure it out.

it has a spark.it is a KT735, mod of lawn mower 13BQA1CZ010