Recent content by mcHarley

I also think, could be an valve issue, check also if the flywheel key isn't broken (timing issue.)

That is correct, but do not forget to disassemble the magnet coil and make it rust-free because rust will not give you a good grounding and result in no spark. When mounting the magnetic coil, the adjustment gap is equal to the thickness of a business card. Good luck. Harry

I use it in my chainsaw.

Did you hit a stone or something else while mowing. After you hit something the mower can be out of balance.

Alko HVC 17 hp.

Mowers I repaired during 14 year.

Stiga Park 12,5 hp Briggs and Stratton, hydrostaat, mowing deck 125cm.

Yes, it is possible there is not enough fuel flow. Open the fueltank and leave open when the engine is running. It is possible if there is not enough air going into the tank then the fuel will stop flowing after a while. When you start the engine after a while, the engine will run for a short...

Does the ignition coil touch the flee wheel? On your photo it look like the coil already cleaned the side off the flee wheel. It may not touch the flee wheel, the gap between both has to be as wide as +/- 2 mm. As Thick as a card.

I don't know if it is allowed to place a link here. If not delete it. Just for help...

Hi, I am not always shure that it is the ignition coil! I see you already took it off. Well if you clean the coil, the side off the flee wheel and the connection where you fasten the ignition coil from rust, the ignition coil needs a good connection to the body of the engine. (Closed circuit)...

Some air out of the tires then chains on and put again some air in the tires untill they are not moving, that should fix your problem. Harry