Recent content by logan01

  1. L

    Kubota BX1870 Deck Height Adjustment

    The hydraulic lift works fine. To set how low the deck will lower, it has a large knob facing forward beneath the front of the seat. I managed to turn it all the way up (clockwise) but couldn't budge it counter-clockwise to lower. A friend of mine as strong as an ape manage to rotate the knob...
  2. L

    Toro MX5480 Shuts Down When Mowing

    Hi folks. Been a while. Title says it all. Might happen at 5 minutes or 30 minutes, etc. Carb has electric fuel shut-off solenoid. Battery is on last legs (2012) and will soon be replaced. If I tap on the bowl it will normally complete the mowing. Average mowing time is anywhere between 1.5 -...
  3. L

    Husqvarna 122L Line Trimmer Carburetor Replacement

    Hi folks. Been a while since I've been on the forum but I've had everything running smoothly for a while. I've had this trimmer since around 1995 and it's been super. Only replacement part has been the muffler and a couple of gas cap gaskets. Gas still leaks out the cap still (I believe) and...
  4. L

    Mower deck Toro MX5480 (Z Mower) Eating Deck Belts

    That time of year again. Mowed 5 times to date. Late last year during the 3rd year of the mower, I noticed the deck belt was severely ripped in two areas, each rip about 1 1/2" long. Mower had about 80 hours on it. Thought I knew the cause but evidently not. My new belt has about 20 hours on it...
  5. L

    Toro OEM / Stens Deck Belt?

    Bought my first replacement deck belt today for my 3 year old Toro Titan 5480 Z-mower (54" cut). Gave my wife the factory part number and she purchased it while in town. Brings it home and it's a Sten. Just shy of 100.00. Actually over 100.00 w/ tax. The belt has the factory sticky paper...
  6. L

    ZT-3100 Vent Plug Hex Size?

    Did my first transmissions fluid / filters change yesterday. Insane. Never got the vent plugs removed. 1/4" seemed to be the size but had a tad of slop. Thought it might be 7mm but didn't have one. Broke three 1/4" allens and stopped with my fourth and last one as it was bending towards...
  7. L

    MX5480 Tracking Adjustment?

    Hi folks. My Titan 5480 pulls to the right just enough be annoying. Though the owner's manual refers to tracking adjustment in the troubleshooting section, no where in the manual is it explained or illustrated. I would appreciate some advice on tracking adjustment. Thank you.
Top