Recent content by lindylex

I am searching for a carburetor to replace this with a high and low adjustment. It has a 15mm venturi and the displacement for the bolt up holes are 32.23 mm center to center. Thanks

Thanks I have never seen or used this acronym before.

What does NLA mean?

I have tried multiple websites and I can not find any parts for this blower. Is there a different way to search for parts? Is there a newer blower with different part numbers I can use? This is what I am searching for. Husqvarna 531009639 GASKET, Husqvarna 531009640 GASKET, Husqvarna...

When I look up eccentric screwdriver I see different heads. Some make sense while others do not. Why is this? For instance "ETA 7750 Eccentric Screw Screwdriver 1.40 ** Swiss Made **" https://www.ebay.com/itm/ETA-7750-Eccentric-Screw-Screwdriver-1-40-Swiss-Made-/264561963223

I have that set minus the Eccentric screwdriver. Looks like I spelled it incorrectly in the original post.

Alas I shall haveth my way with this equipment that I own. I sweareth upon this rock I stand, I shall save it from waste and save my hardware for another day.

I have a Craftsman GAS TRIMMER Model No. 316.791810 Incredi-Pull and it has a very odd looking top for the low and high carburetor adjustments. What tool is used to adjust these? From searching it looks like a Ecceotrix screwdriver. If it is a Ecceotrix screwdriver, where can I purchase...

Thanks you were correct "more precisely the threaded clutch that holds the flywheel against the taper. " It all works well now.

They try to make it all so difficult for anyone to repair.

Thanks dougand3 and bertsmobile1 for the help. I emailed 4 local shops to see if they have parts. I await a response. I have noticed in the past that they have model numbers for parts from newer trimmers that do match. What I have always wanted to know is. Is there a resource where I can...

I am having some difficulty finding parts for this trimmer. This is my issue. I can find them at various sources. Does anyone have a source that might have most of the part so I can minimize on shipping cost? These are the part numbers. 98766A GASKET-Carburetor 06900A GASKET-Heat Dam...

"Nut or bolt whatever holds the flywheel on" has no direct bolt or nut holding it on. What StarTech described is how it is assembled. "You get them to lock by applying a lot of force SLOWLY" I tried this with no success. "Steel wool , scotchbrite 1000 grit wet N dry whatever you have soft...

I will pull it apart and do a nice cleaning. What do you suggest to use to clean this? The key is definitely apart of the flywheel and still there not damaged. What bolt are we talking about?

The key is not damaged. I did place it all back together. I need to poke at it to see how well it stay through the shroud. The washer, spacer, (drive coupler), clutch, and clutch housing are back together. The pull the pull start and the spark is generated. I am concern because of the...