Recently got a stihl FS38 that was missing its carburetor. I went online and purchased a brand new one with all the gaskets and fuel lines etc. I installed the the new carb, fuel line and filter. I noticed that the primer bulb only fills about a quarter full when primed. The trimmer starts, but...
Ive replaced the flywheel key, and torqued the flywheel to the proper specs. It fires a bit longer, just like it is going to start, but it still fails.
Thanks for your help. I just checked into what you said, and found the key in two pieces. I will have to get a new key and check the torque specs for the flywheel.
Hello everyone. I have this vintage Briggs and Stratton 3hp engine that I am restoring. I replaced the old breaker points ignition coil, to the modern electronic magneto coil. After I did that, it started right up and ran perfectly. From there, I removed the carb and gas tank, so I could repaint...