justin@justintime's latest activity

A 1985 3HP very well could have been cast-sleeved or an all-aluminum "koolbore" block but 100% on what you say as far as the koolbores...

Heck, in California they have managed to ban everything to a point no one will be left with anything. I will not go off on a political...

nice job!!!!

I hate this answer, but unfortunately it's true; however, many get jammed up here as well with crankshaft specs.

All day, every day, then they take it to us and have us give an answer they don't like and dont wanna pay. You know the suicide rate of...

Well another DIYer just throwing parts at a problem before knowing what the actual cause is. You must have the correct tools. For...

when a cylinder is honed to an oversize, it is not just the steel that wears away. The stone wears too as the cylinder is honed. There...

Machine shop probably about $150, a little cheaper if you do the finish honing. It can be done with a Lisle rigid hone, and I've done it...

Here is the difference between a cylinder hone and a glaze breaker. The hone is used to enlarge cylinders and keep the bore reasonably...