Recent content by Just Don

  1. J

    17.5HP Intek Briggs and Stratton

    Thank you all this forum is real helpful.
  2. J

    17.5HP Intek Briggs and Stratton

    NO, I haven't figured it out yet. It still won't rev up unless I push the governor arm with my finger.
  3. J

    17.5HP Intek Briggs and Stratton

    Yes, I had to adjust the cable for it to close the choke all the way. I just rebuilt the carburetor so every thing there should be okay.
  4. J

    17.5HP Intek Briggs and Stratton

    It won't rev up by the throttle. I"ll try to do that.
  5. J

    17.5HP Intek Briggs and Stratton

    Thank you. Yes, I had to adjust the throttle cable because it wasn't closing the choke enough to start.
  6. J

    17.5HP Intek Briggs and Stratton

    Updated: The throttle on B&S will choke the carburetor. It won't rev up the engine. I don't see the governor arm moving when I move the throttle. Governor arm will move if I move it with my finger. The governor spring is attached to the throttle like it should be. The springs from linkage to...
  7. J

    Husqvarna YTH24V54 seems to have electrical issues

    Husqvarna YTH24V54 seems to have electrical issues It won't start; it clicks. So I checked the solenoid; the test I did showed it didn't work, so I bought another. Put it on it; it worked. I check the solenoid by touching the bolts with a hot wire and the starter turned over. Went out to...
  8. J

    Putting throttle control on a Honda engine

    I do have a Kohler 19 hp that came off of a lawn tractor. Thanks for your reply bert.
  9. J

    Putting throttle control on a Honda engine

    Thanks for the info and why knots. I do agree this engine shouldn't be used for this purpose.
  10. J

    Putting throttle control on a Honda engine

    I was asking about how to "bypass an automatic governor". Using a lawn engine on a lower end has been done. I have a honda mower off of a power washer good engine with an automatic governor. I don't want to break speed records I just want to get to my fishing hole. I can work on a lawnmower...
  11. J

    Putting throttle control on a Honda engine

    I do see what you saying and it does seem like the little engines won't last long doing that.
  12. J

    Putting throttle control on a Honda engine

    Thanks so much, I learn so much from ppl on forums.
  13. J

    Putting throttle control on a Honda engine

    Okay, that makes sense.
  14. J

    Putting throttle control on a Honda engine

    I took a vertical shaft Honda engine off of a power washer. I want to put it on top of a lower end of a boat motor. My question is what do I need to do to put a throttle controller to operate the speed? The honda has an automatic choke and won't rev up till you start spraying so I need to put a...
  15. J

    HUSQVARNA YTH24V54

    Yes, I'm following it just a remark.
Top