Recent content by JP98

Thanks for your input I'm ordering a compression tester. I am getting spark. I confirmed that using a spark plug/ coil tester. Previous owner said he had replaced ignition coil packs back in 2023. I'm going to take it apart the next weekend or so and will check the valve clearances. Do you...

Hello- I recently bought a Craftsman DGS 6500 fairly cheap. It has a 26 hp Kohler motor. It's in good condition but hard to start and runs rough. The previous owner says it needs a carburetor. I've already changed the spark plugs. Not much improvement. I've been searching the internet and found...

Thanks. I'll try the carb kit and see how that goes. I don't I really want to spend too much money so hopefully it's a cheap fix.

Ok thanks. I'll open the carburetor and take a look. How can I tell if it's good or bad? Should I just replace the carburetor?

Thanks for suggestions. How do I check the float valve? Where is the float valve located at?

My Poulan Pro Riding Mower - PP20VA46 is leaking gas. When I start it, gasoline comes streaming out from the exhaust, it looks like. This is after sitting for a few of days. The gas tank was full the last time I used it a few days prior. There was only a little less than 1/4 left in the tank...