Recent content by Joe Z

The grease gun will not work if the bearing is sealed on the inner side. Why Not to repeat what was already said I read a few of the comments. Did not read all of them but the few I did read gave some good information/ advice. If your bearings are bad it is not too difficult to replace them...

All good advice given. I replaced one on a badboy this past summer the clutch was a bear to get off. I used a mix of 50/50 of transmission fluid & acetone. applied a couple of times during the day & soaked it down over night. Next morning with a little "encouraging" it came off. Do not forget to...