JimP2014's latest activity

Thanks for the additional info, I was not aware that such a thing exists. I believe with this LTS2000 the deck does a front rod ( single...

I will use this pattern also I was watching someone who basically said 4 is not as important as 5 since 5 ( if looser can cause oil...

This is where someone is making their own copper gasket, rather than the spray type out of using Permatex copper.

I never saw this before but I understand what it says. I basically did tighten in this order. I will allow go to the 250 in/lbs when...

Doug thank you very much,, I was thinking about getting a new belt for it. I can't see what you're talking about but I believe you. I...

I posted this about blades removal and then engaging the PTO because I could not figure out why the mower deck and the engine has...

But one thing I did notice is that the last time I replaced the cylinder head gasket was about one year ago. So the question is one year...

I mean with the cylinder head off alrready.

Thank you for this additional information I can tell you that when I was looking at the engine block on the lower right there was a...

Briggs and Stratton 31P677-3373-G2 <--- for this engine I see #54 as being the intake manifold bolts. And that is #54 in the diagram...

here's the video new head gasket so it's just idling although it does cut but I need to get it really cleaned up better than what it is...

Is this message for me regarding the head gasket?

OK I will take your advice on this. The good news is it starts right up and I ran it for a few laps. I guessed on the valve clearance. I...

Blown head gasket image.