Recent content by JAMES2602

I did check flywheel key and compression 170 psi and magnets on flywheel flywheel did not have any cracks and np damage i forgot to mention that i figured someone was going to ask me

Some coils that i have tested over years is because of weak spark that looked to be good but turned out to be bad when tested with ohm meter it did not test in range some other coils i have seen spark but not at rite time again ohm meter found out that it was out of spec on a no spark problem...

I have a husqvarna 240 chainsaw that want start compression is 170 psi and spark is weak , it want jump a 6mm spark gap but it will jump a 4mm i can only get 10,000 kv with a new rcj7y sparkplug ohms reading is 222.5 ohms on primary to ground and 3,115 ohms on secondary to ground when i spray...

I cleaned the carb c1m zama on my 3816 chainsaw and i could not remember what the initial setting where for the high and low speed mixture screws this carb has the air head throttle on top and air fuel throttle on bottom