Recent content by jacknjill

Thank you will see what I can find out. Thanks everyone for the information

Ok thank you

Thanks all for the input. I don't have a way to test the spark except with the inline one I have

Left side 130° right side 224°

He put a spring on the throttle linkage so it would hold it at idel. Just spray a little water on the exhaust coming off each side? Burns off they're firing then

Sorry for the delay was out of town for day. I'll send you a picture within hour thank you again for your help

Snapper zero turn with briggs 26hp model 445877 had issue with high idel. Installed a spring on linkage. Mowed couple hours fine. Now takes a minute to get it started, after it does start when engaging deck it dies out. Also cables get warm when trying to restart. Any thoughts would be greatly...

209A is what I saw in the parts link Jack's Small engine sent me. What I got from Amazon had the two springs, carburetor gaskets, fuel filter, air filter, and the back plate that mounts over carburetor then air filter cover. It has the primer bulb on it that's the main reason I got the kit . It...

I got a new carburetor from Amazon and it came with that little spring and a longer one. Parts diagram I got from Jack's Small engine shows both so I thought maybe it came off and I didn't know it. The yellow lever with long spring pushes forward to choke and back fast idle. But it's not doing...

I'm not sure if these sent yet

This engine is on a Swisher trim-n-mow. I should have stated that sooner my apologies

Here's what I have

Ok. If you by chance you come across a set up like this could you please send me a picture of how it installs. Thanks again

I have a Briggs quantum series 675 model 126T02-0290-B1. There is two springs the longer one goes around the throttle linkage I believe, the smaller I think is called the dentent spring. Does anyone have a picture of where and how it hooks up. Greatly appreciated in advance