ILENGINE's latest activity

  • ILENGINE
    ILENGINE replied to the thread K301.
    And then after you get the spark issue fixed, then you need to concentrate on setting the timing.
  • ILENGINE
    ILENGINE replied to the thread Cant ID drive belts old yardman.
    The problem is your standard dimensions do not apply to John Deere or MTD/Troybilt/Cub Cadet belts because of unique width., depth, and...
  • ILENGINE
    The cap contains charcoal. They have since around 2003-2004 when the new emissions standards started kicking in. It was one of the...
  • ILENGINE
    ILENGINE replied to the thread 8HP Briggs Governor Shaft Leak.
    Parts diagram suggest that one was used. Some engined didn't come from the factory with it installed. There should be a recessed area...
  • ILENGINE
    If fluid gas has entered the charcoal canister it turns it into a solid mass which basically requires the replacement of the cap.
  • ILENGINE
    Most likely the vent is in the cap which also has a charcoal filter canister built into it. So the charcoal could be gas logged, and...
  • ILENGINE
    ILENGINE replied to the thread Need help with wiring.
    Wiring loom is the wiring harness. To @Kingcat MTD is not well known to provide wiring schematics for some for their mowers, and...
  • ILENGINE
    ILENGINE replied to the thread DGT6000 runs rich.
    Similar discussion occurring here https://www.lawnmowerforum.com/threads/cv730-has-me-stumped.82047/
  • ILENGINE
    ILENGINE replied to the thread CV730 has me stumped.
    Changing jets may help. Seems like the Amazon carbs that I have received have all run rich. At least the Kohler carbs, Not so much...
  • ILENGINE
    ILENGINE replied to the thread CV730 has me stumped.
    Was that carb replacement with an OEM carb or the Amazonian chinesium carb that could be part of the run issue. I have had issues with...
  • ILENGINE
    ILENGINE reacted to StarTech's post in the thread JD Z225 Repairs with Like Like.
    The spindles themselves are not bent it is their mounting points which require a sledge hammer to straighten out in the just right spots.
  • ILENGINE
    ILENGINE replied to the thread kawasaki fs730v-bs07 coils.
    Could just be an aftermarket coil issue, But could also be caused by battery voltage backfeeding the coils causing them to burn out...
  • ILENGINE
    ILENGINE replied to the thread JD Z225 Repairs.
    And that is true with a lot of repairs now. Cost to repair is more than the mower is worth but a replacement mower is 4-10 times the...
  • ILENGINE
    ILENGINE reacted to Tiger Small Engine's post in the thread New Blade clutch questions with Like Like.
    Remove a spark plug and install a piston stop, or take good nylon rope and stuff it into the spark plug hole until full. This will keep...
  • ILENGINE
    A lot of "grey stuff" in the oil pan. I suppose that was the remaings of the cam lobe.....
Back
Top