ILENGINE's latest activity

My first thought is the choke isn't fully closing. Need to make sure choke butterfly is fully closed when the throttle control is set...

I know that feeling. Worked on a Honda TRX450 a few years ago that lost spark. Actually would spark once when the start button was...

I spent 3 days trying to figure out how the start cycle was bypassing the unplugged seat switch, pto switch, clutch switch, and the key...

The only think I can think of is, The K2 ignition relay terminal 86 uses the the same X2 pin D as the ground. And with the pin D open...

I have seen it on trailers over the years also. Loose the ground and the system will try to use the lights as the ground because some...

Totally doesn't make sense. Pin H on the circuit board is a pin with no circuit connected to it. There is no copper strip leading...

Hello ILENGINE, Glad you resolved it. It's always an adventure to come in behind a DIY who thinks swapping and moving wires around...

Got it figured out. Wire in wrong location on X2 connector on the circuit board 130 Ground wire was in slot H not slot D. Figured...

Engine will even crank with the seat switch, pto switch, and brake switch unplugged. just have to turn key to on position. Not even...

I am thinking the same. Some wire is crossing over inside of the loom.

No. Appears to be on the control side of the circuit board wiring that is closing the start relay.

This one has me puzzled. Engine starts cranking as soon as the key is switched to the on position. New JD key switch/circuit board...

You can go to the websites of Rotary, Oregon, or Stens. Put in your Toro part number and get several aftermarket alternatives. The...

Looks like that mower used the 44G777-0400-E1 Briggs engine. Check the vacuum tube between the valve cover and the fuel pump to make...

Find the product ID label on your mower and look up the parts on Parts Tree. No, a JD 48" deck is not the same as one on a Husqvarna...