ILENGINE's latest activity

Heavy scoring on piston in picture. Stop and don’t do any further work on chainsaw. Leave muffler off so you can show customer or know...

Or owner didn't add enough/any oil to the fuel

My questions: 1) Is 125 psi sufficient compression? Yes 2) Assuming compression is sufficient and given that crankcase holds vacuum...

If you have a tax ID number you can get a Stens account and buy tax free. Also Stens has store on amazon. Parts are a few dollars more...

Very odd that both would fail at the same time. But will also consider the fact that they may be related. Engine codes would be...

On the Intek V-twins the push rod will fit through the oil drain back hole from the push rod cavity. Could be the push rod got jammed...

I don't think he is talking about the flywheel key shearing..He is talking about the keyway on the pto end of the crankshaft being...

I'm kinda getting the drift from all the people who have had first hand experience with this "little yellow gadget" that this is a not a...

I use NO-Ox myself on some items. Use lots of dielectric grease around the shop, just not on electrical connections

That why I use an electrical grease that is suppose prevent oxidation in the household electrical panels. It is conductive.

I just love when people recommend coating electrical connections with non conductive grease.

Either you have a bad wire connector, most commonly at the battery, but could be were the ground wire connects to the frame, or the...

Very few shops rebuild small engines anymore, including me. It takes too long, too much liability, and not enough money for all the work.

Remove the bolt to the right of the fuel cap and the tank and carb should come off together than you can separate the carb from the tank.

Fuel tank is integral with the rear handle part number 525862104, subs to 537437906. And doesn't come with fuel lines, or any of the...