ILENGINE's latest activity

I normally jack up the rear wheels and put blocks under them to hold the mower up to give clearance without the jack being in the way...

Or the mower because the battery was obsolete before the mower was even purchased.

Most likely it has broken compression rings or a badly worn cylinder allowing too much pressure back into the crankcase. A failed...

So I'm going to conclude that you are telling me I need to detach the whole hydraulic hose from the steering box so that it will turn to...

Snapper used about a half dozen different discs. Need model number to determine which one you need.

Thanks. I'll get model info tomorrow.

Hydrostat belt either came off or broke. Need to look up under the rear of the mower, above the deck belt

Deck drive belt should come off the left side of the center spindle pulley, go to the right of the flat pulley behind the center spindle...

If this is the setup I think it is Snapper has a very similar mower and the swivel fitting for the hydraulic hose going to the cylinder...

Agree, The word if true or not about filling housings is anedotal at this point. One source says to not fill a wheel bearing...

Not the greatest picture but may be able to blow it up and see how everything is sitting https://a.co/d/ePKyaFv

@GearHead36 I don't know if it was a proven fact or some word of mouth that spread about, with the original reason being trying to...

That was the concern with overpacking wheel bearings. The extra grease causes heat retention leading to premature bearing failure. You...

Need to double check that ohm reading. Because if that 1 ohm is accurate that clutch is pulling 12 amp. Resistance should be in the...

Green wire on Kohler engines normally goes to the oil pressure switch either next to the oil filter or on some Command engines the oil...