ILENGINE's latest activity

If the existing O rings are in good shape then reinstall them. Don't remove and use the other gaskets or try to put the gaskets over...

All of the single cylinder engines used on Generac products are rebranded engines. The V-twin is the only Generac built engine.

Your description sounds like a badly worn Deck PTO switch. https://www.partstree.com/parts/snapper-1738982yp/

The disc should unscrew from the shaft collar. The shaft collar is held on by if I remember correctly 2 set screws, and then should...

Here is the correct plug for comparison Notice the thread length difference and the washer instead of the tapered seal

If you are talking about the tan ring next to the float vavle that is the seal for the fuel solenoid on the bottom of the bowl.

The ones that irritate me are the ones where you go to pull them out the plastic comes off leaving the entire metal fuse body in the holder

Didn't happen to have the deck engaged and forgot to push down the pto switch button.

Looks like Ohio has 431, NY has 589, NC has 612, TX has 53, and UT has 214, and IA is out of stock but that is PD's version of a...

This is all adding up to a failed compression release. Aftermarket cams are junk and genuine Briggs are on backorder the last time I had...

I understand your fustration, but go out into the country sometime then they are mowing side ditches with the rotary cutters and half...

That is about the correct location for rod breakage when the rod seizes to the crank from lack of lubrication failure. And the bolts...

Welcome aboard. Thank you for your service. USA (1986-90) E5 Tacfire operations specialist 13C20.

This should be the belt routing

You missed the point that the rod/crank journal bearing overheating is the cause for the rod bolts loosening. The loose bolts are not...