ILENGINE's latest activity

After looking at your parts diagram it appears that engine has the Kohler Command with the solenoid shift starter. It could be just...

Fuel flow restriction going into the carb. And the engine is running long enough to drain the fuel bowl on the carb. And wlll probably...

When looking at the parts diagram for your mower it appears the diagram doesn't match the parts on your mower. It looks like the...

Battery not charging and the electric clutch shutdown after the battery got low enough, and now doesn't have enough lightning bolts left...

People tend to use coil and ignition module interchangeably but are not the same thing actually

MTD and JD do not use standard width or length belts. And cannot be substituted because they will not work properly or get damaged in a...

Sheared flywheel key in this won't prevent spark. Would effect starting and running but will still produce spark.

Technically it is a CDI. The new style briggs ignition modules are Capacitive Discharge Ignition.

Or the wheel motor has seized. Have worked on this exact model where the wheel motor would seize after getting hot. Jack up the left...

The belt chunking a section is most likely the problem. Make sure you take pictures of how the old one is routed before you remove it...

1/8" valve opening is about half of what they should open. And I currectly have 2 OEM cams on backorder with an ETA of October.

And that was based on the idea that synthetic oil wouldn't allow the rings to wear in properly to seat. And the truth is most engines...

Does the throttle in the carb move freely without binding. If so then I would honestly say the governor gear inside the engine is roached.

Does the throttle in the carb move freely without binding. If so then I would honestly say the governor gear inside the engine is roached.

If you watch the video the tach is showing 4660.