Recent content by Howho

  1. H

    Husqvarna Carb malfunction Yta 22v46 Model - 960430212 Series - 030816A003570

    Would you replace the jets first? Sure doesn’t sound like a push rod when it runs, it runs smoothly.. I know it’s a Briggs and Stratton but that’s all I know about the engine it’s still at the repair shop.
  2. H

    Husqvarna Carb malfunction Yta 22v46 Model - 960430212 Series - 030816A003570

    I have a Husqvarna Yta 22v46 Model - 960430212 Series - 030816A003570 it’s approximately a 2018 year model. It runs on idle but when you incrase increase speed It starts surging but will not increase the RPMs/power. It also seems to spit fuel out of the carb. I’ve had the mower at a repair shop...
  3. H

    problem going foreward

    Ok I checked and all pulleys are working normal with no issues. However my main drive belt seems too loose to me. Where it goes through the idlers it doesn’t seem very tight, is there a way to adjust the belt tension, I have the exact OEM drive belt, could it be that it is slightly too long...
  4. H

    problem going foreward

    THANKS
  5. H

    problem going foreward

    Will do
  6. H

    problem going foreward

    I did but I'll recheck to be sure the idler pullies are good. If they seem loose do I replace springs next they seem normal, but should I replace them to be safe. However, I did specifically check the variable speed pulley and it was free up and down. Would the next step be to replace the...
  7. H

    problem going foreward

    LTX 1040 (13RX90AS056) - Cub Cadet 42" Lawn Tractor (2010) 956-04015A Variable Speed Pulley I have the exact same problem. Replaced the belts with new OEM belts and I still have the same issue. Starts off hard then if you go up a slight hill it slows to a stop. Push the accelator pedal...
  8. H

    Ltx 1040 is creeping

    Mine also when I back up its like it tightens up then in a few seconds it slows again especially going uphill. My Model LTZ 1040 No. 19A30003100 Serial 1D1190J10201, 42" Kohler Courage
Top