hlw49's latest activity

You try unbolting the engine and see if you can move it around enough the get the belt off and on. Otherwise it is likely you will need...

Did you clean the pilot jet?

Be sure the bowl vent for the carburetor is not blocked or restricted. Sometimes the air cleaner gasket or even the air cleaner plate...

The small spring mutilated and streatched to put more tension on the governor. The large one it hooked wrong. It goes inside the loop on...

When you set the static gov adjustment be sure you are torquing the gov arm clamp bolt to 130 inch lbs. That sounds like what happend in...

Just another one of our products going the Chinese....American companies are just sell outs...And we will be at the mercy of the Chinese...

Most engines turn around 3600 rpms and drop about 100 to 200 rpms when blades are engaged.

Hold the governor link so the engine idles if it dies it is dirt in the idle circuit of the carb.

If you start applying the choke does it start to smooth out prior to going rich from too much choke, Or does the surging stop when the...

The ign switch does not supply power to the ignition modules. In the off position it grounds the kill circuit. In the run position it...

Yes it has a fuel pump.

GTV760 0050581 I hate the way Generac does their model no.s

like ILENGINE said most of the time the bolt is not tight when they break off and turn out easily. You can try a left hand drill bit...

You may be able to take a small punch and catch the edge of the broken bolt and with small taps spin the broken bolt out. Most of the...

That is a lot of oil in such a short time. That engine holds 2.4 quarts of oil. If you want to save it you should check it more often...